I assigned the bridge an IP of 192.168.X.X, but Squid would not work. So I assigned the 3rd interface this IP and removed it from the bridge, now it works. I guess I didn't set up routing, but the third interface is just using DHCP - what is missing - the gateway? DNS already in resolv.conf...
mt
-----Original Message from Henrik Nordstrom <hno@squid-cache.org>-----
On Wed, 24 Mar 2004, Matthew Tanase wrote:
> OK - I have gotten it working, but not sure if it is optimal. Linux, 3
> network interfaces. eth0 and eth1 acting as the bridge, assigned an IP.
> eth2 - not connected. Couldn't get anything to work wtih squid, although
> the bridge worked. So I enable debugging and can see that Squid cannot
> talk to the network, it is set to run on the IP assigned to the bridge.
> So I plug the third interface, eth2 into the network and assign it the
> squid IP - everything works. But now all 3 interfaces are in use. Can
> someone tell me what I am doing wrong with the bridge IP?
Which interface did you set the IP on? Should be on the bridge interface,
not the physical interfaces.
Did you remember to set up routing?
Can you ping to/from the bridge box?
Regards
Henrik
Received on Thu Mar 25 2004 - 06:11:04 MST
This archive was generated by hypermail pre-2.1.9 : Thu Apr 01 2004 - 12:00:03 MST